Search results for "Full width at half maximum"
showing 10 items of 89 documents
Phosphorous doping and drawing effects on the Raman spectroscopic properties of O=P bond in silica-based fiber and preform.
2012
International audience; We report an experimental study of the doping and drawing effects on the Raman activities of phosphorus (P)-doped silica-based optical fiber and its related preform. Our data reveal a high sensitivity level in the full width at half maximum value of the 1330 cm−1 (O = P) Raman band to the P-doping level. Its increase with the P doping level does not clash with an increase in the disorder of the O = P surrendering matrix. In addition, we observe that in the central core region of the sample (higher doping level), the drawing process decreases the relative band amplitude. We tentatively suggest that this phenomenon is due to the change in the first derivate of the bond…
X-ray response of CdZnTe detectors grown by the vertical Bridgman technique: Energy, temperature and high flux effects
2016
Abstract Nowadays, CdZnTe (CZT) is one of the key materials for the development of room temperature X-ray and gamma ray detectors and great efforts have been made on both the device and the crystal growth technologies. In this work, we present the results of spectroscopic investigations on new boron oxide encapsulated vertical Bridgman (B-VB) grown CZT detectors, recently developed at IMEM-CNR Parma, Italy. Several detectors, with the same electrode layout (gold electroless contacts) and different thicknesses (1 and 2.5 mm), were realized: the cathode is a planar electrode covering the detector surface (4.1×4.1 mm2), while the anode is a central electrode (2×2 mm2) surrounded by a guard-rin…
Improved electroless platinum contacts on CdZnTe X- and γ-rays detectors
2020
AbstractPlatinum is a promising candidate for the realization of blocking electrical contacts on cadmium-zinc-telluride (CdZnTe or CZT) radiation detectors. However, the poor mechanical adhesion of this metal often shortens the lifetime of the final device. In this work, a simple and effective procedure to obtain robust platinum contacts by electroless deposition is presented. Microscopical analysis revealed the final thickness and composition of the contact layer and its adhesion to the bulk crystal. The blocking nature of the Pt-CdZnTe junction, essential to obtain low noise devices, was confirmed by current–voltage measurements. The planar Pt-CdZnTe-Pt detectors showed good room temperat…
Transition-Edge Sensors for Particle Induced X-ray Emission Measurements
2013
In this paper we present a new measurement setup, where a transitionedge sensor detector array is used to detect X-rays in particle induced X-ray emission measurements with a 2 MeV proton beam. Transition-edge sensors offer orders of magnitude improvement in energy resolution compared to conventional silicon or germanium detectors, making it possible to recognize spectral lines in materials analysis that have previously been impossible to resolve, and to get chemical information from the elements. Our sensors are cooled to the operation temperature (65 mK) with a cryogen-free adiabatic demagnetization refrigerator, which houses a specially designed X-ray snout that has a vacuum tight window…
Determination of the crystallinity of TiO2 photocatalysts
2018
Abstract This study reports a new simple method to determine the crystallinity of anatase and rutile TiO2 photocatalysts. The crystallinity degree of various anatase and rutile samples was estimated by XRD analysis from the ratio among the full width at half maximum intensities of the main diffraction peaks of anatase or rutile and the (111) peak of CaF2 as internal standard. The photocatalytic activity of selected powders was tested employing the photodegradation of 4-nitrophenol in aqueous solution as probe reaction. The results showed that the photoactivity of the investigated samples increased with increasing crystallinity and crystallite size.
Study of the structural changes induced by air oxidation in Ti–Si–N hard coatings.
2008
International audience; 3-μm thick Ti–Si–N coatings were deposited on polished X38CrMoV5 substrates by sputtering a composite Ti–Si target in Ar–N2 reactive mixture. Oxidation tests were performed in air at 700 °C during 2 h. Whatever the silicon content in the range 0–4 at.%, no silicon containing compound was detected by XRD before air oxidation and only the TiN phase was evidenced. The mean grain size estimated from the full width at half maximum of the TiN (111) diffraction peak was close to 10 nm. As commonly reported for Ti–Si–N films, the hardness showed a maximum at 51 GPa versus the Si content. After oxidation of the TiN film, XRD and micro-Raman analyses revealed the occurrence of…
Comparison of the H-alpha circumstellar disks in Be/X-ray binaries and Be stars
2000
We present a comparative study of the circumstellar disks in Be/X-ray binaries and isolated Be stars based upon the H-alpha emission line. From this comparison it follows that the overall structure of the disks in the Be/X-ray binaries is similar to the disks of other Be stars, i.e. they are axisymmetric and rotationally supported. The factors for the line broadening (rotation and temperature) in the disks of the Be stars and the Be/X-ray binaries seem to be identical. However, we do detect some intriguing differences between the envelopes. On average, the circumstellar disks of the Be/X-ray binaries are twice as dense as the disks of the isolated Be stars. The different distribution of the…
High-resolution photoacoustic Raman spectroscopy of gases
1992
A high-resolution photoacoustic Raman spectroscopy experiment is described. The resolution achieved by using two single-mode pulsed lasers is about 0.0054 cm −1 (full width at half maximum intensity). The experiment was tested first on the v 1 /2v 2 bands of CO 2 and gave an increase of at least about one order of magnitude in the signal-to-noise ratio with respect to stimulated Raman spectroscopy at low pressure (ca. 10 Torr ≃ 1.3 kPa). The sensitivity is also demonstrated by the study of the weak hot band v 1 +v 2 −v 2 of CO 2 . In both cases, the experimental line shape is well reproduced by taking into account Doppler and collisional effects. A comparison with CARS spectra was also made
In-situ monitoring by Raman spectroscopy of the thermal doping of graphene and MoS2 in O-2-controlled atmosphere
2017
The effects of temperature and atmosphere (air and O2) on the doping of monolayers of graphene (Gr) on SiO2 and Si substrates, and on the doping of MoS2 multilayer flakes transferred on the same substrates have been investigated. The investigations were carried out by in situ micro-Raman spectroscopy during thermal treatments up to 430 °C, and by atomic force microscopy (AFM). The spectral positions of the G and 2D Raman bands of Gr undergo only minor changes during treatment, while their amplitude and full width at half maximum (FWHM) vary as a function of the temperature and the used atmosphere. The thermal treatments in oxygen atmosphere show, in addition to a thermal effect, an effect a…
Radiation damage in zircon
2003
A single, zoned, Sri Lankan zircon exhibits a range of microstructures from crystalline to nearly amorphous that are the result of radiation damage over a dose range of 2.1–10.1·1015 α-decay events/mg (0.16–0.47 dpa). The zones in the crystal were examined at a variety of length scales using optical microscopy, micro-Raman spectroscopy, electron microprobe analysis, and transmission electron microscopy. Birefringence varies linearly with dose: birefringence = −4.71·10−18 /g· D α + 4.86·10−2. Full width at half maximum (FWHM) measurements of the B1g(ν3) peak, as determined by micro-Raman spectroscopy, were used to estimate the extent of radiation damage in each zone. The radiation dose (calc…